Cansonic ULTRADASH Z3+C, Инструкция по эксплуатации

Страница: 58 / 60

56
Standard
Security
Frequency Range
Transfer Rate
Output Power IEEE802.11n
WPA2
2400-2483MHz ISM band
150Mbps (802.11n)
9.46dBm±2dB (802.11n)
Wireless Link Specification
GPS Specification
Frequency Range 1559-1610MHz
Appendix
If you continue to have problems with your Cansonic UltraDash
Z3+C, please reset your camera to default settings in the setup
menu and begin the process over again.
If these problems remain, please describe your question and
send it to service_usa@cansonic.com or call our customer
service number provided on the Cansonic Website.
Unresolved Issues
FCC Warning
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any inte rference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
FCC NOTE
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interferenceto radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.