JP1 AND LED1
C:
RECEIVED SIGNAL STRENGTH INDICATION (RSSI) ADJUSTMENT
(Top 2 pins) = RSSI is
OFF
(default position maximum sensitivity and
range).
(Bottom 2 pins) = RSSI is
ON
. Carefully adjust
for range. For noise
rejection set VR1 just below the point that causes LED1 to turn off.
NOTE:
will be constantly flashing if unit is at maximum sensitivity or if
is set to Maximum Range.
It is best to operate the SFR-200 is with the RSSI jumper set to OFF (receiver
is set to its maximum receive range).
Smartfob Receiver MN: SFR2RXB
Page 7 of 17
Installation Manual
July 2008 • Rev. 1.0
