1、Connect to power supply after installation complete, blue light twinkle three times is
normal work;
2、Open central management software,click remote open door,blue light on,press PUSH ，
hand shank bounce,if timeout not open then will lock automatically;
3、Use authorized card swip on the hand shank read card area,blue light on,press PUSH ，
hand shank bounce,if timeout not open then will lock automatically, Unauthorized
card after swip card the red light twinkle two times;
4
、
Door switch input can set as normally open or normally close,after status change then
occur alarm,red light twinkle,and send alarm signals to the center.
Electricity test
1
Fig 1
Fig 2
change the “galvanized
washer”direction
，
select left
open or right open
left open
right open
support rods
unit : millimeter
Fig 4
lock body
door frame
galvanized washer
washer
locking tabs
locking tabs's washer
locking tabs' screw
pressure plate's screw
pressure plate
Fig 3
Installation Instruction
s
Installation Steps
1
、
According
to
picture shown
,
the
size
punching well the installation hole in fit
height of cabinet door
（
suggest 1.1 m
or middle
;
2
、
Unscrew
lock's pressure plate's screw
and locking tabs' screw ,take the washer
and galvanized waher then tak the
pressure plate;
3
、
Put the lock's lead wire through the
hole thread from outside to inside of
the door Hold the lock on the door;
4
、
Put the lock's lead wire thread from
the biggest square hole of the pressing
plate
（
note Fig 3 direction
）
,
then use
pressure plate
fixed screw fix well;
5
、
Install galvanized washer
、
shim and
locking tabs,as Fig 2 shown select left
open or right open,use wrench fix well
the support rods
（
suggest as Fig4 add
a
support rods,make the connection
more
stronger;
6
、
According user manual or lock body's
connection definition connect well lead
wire;
7
、
Installation complete.
3
、
The device using 12V DC power supply
，
please ensure connection correctly then
electricity use,to avoid making the device
broken.
www.canovate.com
Preparatory work
：
cross
screwdriver,Φ32
dowelling
jig，sander，10MM hexagonal-
wrench（adjustable wrench）.
