Canon XF400, Инструкция по эксплуатации

Страница: 75 / 164

75
S etting the Time Code
Setting the Time Code’s Initial Value
If you set the running mode to [ Preset], you can set the initial value of the time code.
1 Select [Initial Time Code].
>
[
3
#
Recording Setup]
>
[Initial Time Code]
• The time code setting screen appears with an orange selection frame indicating the hours.
• Touch [Reset] to reset the time code to [00:00:00:00] and return to the previous screen. If the running mode
is set to [ Free Run], the time code will be reset the moment you touch the button and keep running
continuously from 00:00:00:00.
2 Touch [
Í
] or [
Î
] to set the value for the hours and then touch the minutes field to select it.
• Change the rest of the fields (minutes, seconds, frame) in the same way.
3 After completing all the fields of the time code, touch [OK].
• Touch [Cancel] to close the screen without changing the time code.
• If the running mode is set to [ Free Run], the time code will start running from the time code entered
the moment you touch [OK].
4 Touch [
X
].
NOTES NOTES
• When slow & fast motion recording is activated, you cannot select the [ Free Run] running mode.
Conversely, when pre-recording is activated, [ Free Run] is set automatically and cannot be changed.
• When slow & fast motion recording is activated, the time code signal cannot be output from the SDI OUT
terminal (
m
only) or HDMI OUT terminal.
• When the camcorder is set to external recording-only mode, the time code mode cannot be set to
[ Regen.].
• When you are using the [ Free Run] running mode, the time code will continue running as long as the
built-in backup battery has some charge left, even if you disconnect all other power sources. However, this is
less accurate than when the camcorder is on.