Canon w-e1, Инструкция по эксплуатации

Страница: 36 / 98

36
To start with, check if the access point supports WPS* that allows easy
connection between Wi-Fi devices.
If you do not know if the access point you use is WPS-compatible, refer
to the access point instruction manual or other documentation.
* Wi-Fi Protected Setup

When WPS is supported
The following two connection methods are available. Connection
can be established easier with WPS (PBC mode).
• Connecting via WPS (PBC mode): Perform the operations
described on page 37.
• Connecting via WPS (PIN mode): Perform the operations
described on page 41.

When WPS is not supported
• Connecting to a detected network manually: Perform the
operations described on page 45.
Access Point Encryption
This camera supports the following options for [ Authentication ] and
[ Encryption settings ]. Therefore, when connecting to a detected
network manually, the encryption used by the access point must be one
of the following.

[ Authentication ]: Open system, Shared key, or WPA/WPA2-PSK

[ Encryption settings ]: WEP, TKIP, or AES
Checking the Type of Access Point

If stealth functions of the access point are active, connection may
be disabled. Deactivate stealth functions.

When connecting to a network that has a network administrator, ask the
administrator about the detailed setting procedures.
If the network you use filters by MAC address, register the MAC address of
the W-E1 at the access point. The MAC address can be checked on the
[
General sett. ] screen (p.72).