Canon Super G3 FAX Board-AR1, Руководство по обслуживанию

Страница: 55 / 69

6
6
Installation_Super G3 FAX Board-AR1
Installation_Super G3 FAX Board-AR1
6-9
6-9
Installation_Super G3 FAX Board-AR1 > Installation Outline Drawing
Installation_Super G3 FAX Board-AR1 > Installation Outline Drawing
Operation Setting
Type setting
Select the country/region of the FAX Board in Service Mode (level 1) : FAX > TYPE > TYPE
This setting performs the parameter settings to match the communication specification of the
country/region.
1) Set the TYPE of country/region to install this machine, and then press OK.
• Service Mode (level 1) > FAX > TYPE > TYPE
2) Confirm that service mode (level 1) parameter below is "0". In the case, parameter is "1",
change to "0.
• Service Mode (level 1) > COPIER > OPTION > DSPLY-SW > SDTM-DSP
NOTE:
To change parameter to "0" makes no show below [Settings/Registration] >
[Preferences] > [Timer/Energy Settings] > [Restrict Auto Reset Time] and auto shut
down is not available.
3) Turn OFF/ON the main power switch to enable this setting.
Basic Setting
NOTE:
When “System Manager Information Settings” is set, be sure to follow the direction of
user administrator in order to log in as an administrator.
In this section, make only minimum settings required for FAX communication.
1) User Telephone Number
[Settings/Registration] > [Function Settings] > [Send] > [Fax Settings] > [Set Line] > [Line 1]
> [Register Unit Telephone number] > Enter the fax number > [OK]
2) Type of Telephone Line
[Settings/Registration] > [Function Settings] > [Send] > [Fax Settings] > [Set Line] > [Line 1]
> [Select Line Type] > Select the type of the connection line > [OK]
3) Turn OFF/ON the main power switch after setting the user telephone numbers and the type
of telephone line.
Fax communication test
Perform the communication test to check if FAX function works Correctly.
1) Switch the control panel display to [Fax] display.
2) Send the test document from this machine to another machine that can handle the
communication test to check that this machine can send the data correctly.
3) Send the test document from the target to this machine to check if the machine can receive
the document properly .