5
5
Service Mode
Service Mode
5-7
5-7
Service Mode > Setting of Bit Switch (SSSW) > Bit Switch Composition > SSSW-SW05
Service Mode > Setting of Bit Switch (SSSW) > Bit Switch Composition > SSSW-SW05
■
SSSW-SW04
●
Functional Construction
Bit
Function
1
0
0 not used
-
-
1 not used
-
-
2 the number of final flag sequences of protocol
signals
2
1
3 Reception mode after CFR signal transmission high speed
high speed/low speed
4 the length of the period of ignoring low speed
signals after CFR output
1500 msec
700 msec
5 not used
-
-
6 not used
-
-
7 not used
-
-
Detailed Discussions of Bit 2
Use it to select the number of last flag sequences for a protocol signal (transmission speed at
300 bps). Select '2' if the other party fails to receive the protocol signal properly.
MEMO: Any of the following error codes may be indicated at time of transmission
##100, ##280, ##281, ##750, ##753, ##754, ##755, ##758, ##759, ##760, ##763
##764, ##765, ##768, ##769,##770, ##773, ##775, ##778, ##780, ##783, ##785,
##788
Detailed Discussions of Bit 3
Use it to select an appropriate reception mode after transmission of the CFR signal.
If errors occur frequently at time of reception because of the condition of the line, select 'high
speed' for reception mode and, at the same time, selects 'do not receive' for 'ECM reception.'
MEMO: Any of the following error codes may be indicated at time of reception because
of line condition
##107, ##114, ##201
Be sure to change bit 4 before changing this bit; if errors still occur, change this bit.
When 'high speed' is selected, only high-speed signals (images) will be received after
transmission of the CFR signal.
Detailed Discussions of Bit 4
Use it to select the time length during which low-speed signals are ignored after transmission
of the CFR signal.
If the condition of the line is not good and, therefore, the reception of image signals is difficult,
select '1500 msec.'
T-5-5
■
SSSW-SW05
●
Functional Construction
Bit
Function
1
0
0 not used
-
-
1 Conversion from mm to inch (text mode)
convert
do not convert
2 Conversion from mm to inch (text/photo mode)
convert
do not convert
3 end DIS signal bits 33 and over
prohibit
do not prohibit
4 Recording paper length availability declared in DIS signal A4/B4 size
any size
5 not used
-
-
6 not used
-
-
7 not used
-
-
Detailed Discussions of Bit 1
Use it to enable/disable millimeter/inch conversion in sub scanning direction for images read
in text mode.
Detailed Discussions of Bit 2
Use it to enable/disable millimeter/inch conversion in sub scanning direction for images read
in text/photo mode while bit 1 is set to '1'.
Detailed Discussions of Bit 3
Use it to enable/disable transmission of bit 33 and thereafter (DIS signal).
Caution:
If 'prohibit' is selected, the Super Fine reception function or Memory Box function cannot
be used for communications from non-Canon machines.
Detailed Discussions of Bit 4
Use it to enable/disable declaration of the use of cut sheets (DIS signal).
For reception of an extra-long original, select 'A4/B4 size' if division is to be by the other party.
MEMO:
Some machines are not designed to divide extra-long originals.
T-5-6
