Canon PowerShot G11, Руководство по обслуживанию

Страница: 63 / 91

11
<How to detach the Connector>
Detach the connector from the CN4001 by following the instructions shown below.
How to detach the Connector
Do not insert into a
connector end (corner
portion of the connector)
Do not insert into a
connector side.
Do not insert obliquely.
Recommended slotted screwdriver
Procedures
Width: 2 mm or more
Thickness: 1.2 mm or less
1 Insert the tip of the slotted screwdriver straight into the gap between the connector and the
circuit board.
Insert the tip of the screwdriver into
the gap between the connector and
the circuit board.
Lift up the connector in
the vertical direction with
the tip of the screwdriver.
Positions where the screwdriver tip
should be inserted
Note: Do not insert the screwdriver tip into the
following positions.
Screwdriver
Connector
Alternately lift up the right and left sides of the connector little by little to detach it.
Note: In order to prevent the connector from being damaged, avoid detaching the
connector at one stroke.
* Other cautions
NG
NG
NG
1. Do not lift up the connector by the cable as this may break the cable or
damage the connector.
2. Do not attach and detach the connector more than 30 times.
1
2
2