MECHANICALSYSTEM
4.
the
and Blade
1)
the surface using
alcohol solution to
prepare for the attachment of the
2)
Attach the
seals the locations shown
Figures 4-80 and -81; short, then long
round
of
end
round
of
developing assembly are matched.
Figure 4-80 (front view)
Note:
Attach the
so that the long round hole of
end
and the round hole of the
developing assembly are matched.
Figure 4-81
section)
Note:
Put the
and
(long)
together as shown, and attach them around the
developing assembly.
Make
that the shorl and long seals are
positioned as shown Figure 4-81.
3)
Mount parts
the blade.
For the gear, engage long tooth a and
b
to put the
together.
Figure
4-82
4) Push the blade mount against the developing
cylinder the direction of the developing
assembly, and tighten the two screws.
Figure 4-83
5)
Loosenthefourscrewsthat holdthebladeon the
blade mount, and re-tighten them.
Note:
Do not
the screws too
the blade may come off the positioning
at
the center.
CANON INC.
CANON
JAN.
IN JAPAN
4-27
Содержание NP-2020
Страница 5: ......
Страница 171: ...LL w I n t 0 m a 9zcr 9zcr ...
Страница 172: ...I I i I am w m h I I r l I I B m 0 4 u I m ll ...
Страница 178: ...STAL SERVICE MANUAL COPYAIGHT 0 1592 CANON INC CANON NP2l20 2020 KV 0 MAY 1990 PAINTEO IN JAPAN IMPRIME AU JAPON ...
