Canon MP540, Упрощенное руководство по обслуживанию

Страница: 3 / 58

(3/58)
Error
Error
code
U No. Message on the LCD Solution
Warning: The ink
absorber becomes
almost full.
[1700,
1701]
--- Contact the support center or
service center for ink
absorber replacement. Press
[OK] to continue printing.
Replace the ink absorber, and reset its
counter. Pressing the OK button will exit
the error, and enable printing without
replacing the ink absorber. However,
when the ink absorber becomes full, no
further printing can be performed unless
the applicable ink absorber is replaced.
The connected digital
camera or digital
video camera does
not support Camera
Direct Printing.
[2001] --- The device may be
incompatible. Remove the
device and check the manual
supplied with the connected
device.
Remove the cable between the camera
and the machine.
The remaining ink
amount unknown.
[1683] U130 (Applicable ink tank icon)
The remaining level of the
following ink cannot be
correctly detected. Replace
the ink tank.
An ink tank which has once been empty
is installed. Replace the applicable ink
tank with a new one. Printing with a
once-empty ink tank can damage the
machine.
To continue printing without replacing
the ink tank(s), press the Stop button for
5 sec. or longer to disable the function to
detect the remaining ink amount. After
the operation, it is recorded in the
machine EEPROM that the function to
detect the remaining ink amount was
disabled.
Ink tank not
recognized.
[1684] U140 The following ink tank cannot
be recognized.
(Applicable ink tank icon)
A non-supported ink tank (an ink tank
that is sold in a different region from
where the machine was purchased) is
installed (the ink tank LED is turned off).
Install the supported ink tanks.
Ink tank not
recognized.
[1410
to
1419]
U150 The following ink tank cannot
be recognized.
(Applicable ink tank icon)
A hardware error occurred in an ink tank
(the ink tank LED is turned off). Replace
the ink tank(s).
No ink (no raw ink). [1688] U163 Printer detected ink out
condition of the following ink.
Replace the ink tank.
(Applicable ink tank icon)
Replace the empty ink tank(s), and close
the scanning unit (cover).
Printing with an empty ink tank can
damage the machine.
To continue printing without replacing
the ink tank(s), press the Stop button for
5 sec. or longer to disable the function to
detect the remaining ink amount. After
the operation, it is recorded in the
machine that the function to detect the
remaining ink amount was disabled.
Non-supported hub [2002] --- An unsupported USB hub is
connected. Remove the hub.
Remove the applicable USB hub from
the PictBridge (USB) connector.