Canon iP4680, Упрощенное руководство по обслуживанию

Страница: 6 / 21

(6/21)
Cycles of
blinking of
Alarm and
Power LEDs
Error
Error
code
Conditions
Solution
(Check points and replacement items)
7 times Ink absorber full [5B00,
5B01]
The ink absorber is
supposed to be full.
Error codes:
5B00: Main ink absorber is
full (overseas).
5B01: Main ink absorber is
full (Japan).
1) Ink absorber condition
2) Part replacement:
- Ink absorber kit
3) Ink absorber counter value in the
EEPROM;
reset the ink absorber counter.
8 times Print head
temperature rise
error
[5200] The print head temperature
exceeded the specified
value.
1) Print head condition
2) Cable connection
3) Part replacement:
- Print head
- Logic board
9 times EEPROM error [6800,
[6801]
A problem occurred in
reading from or writing to
the EEPROM.
1) Part replacement:
- Logic board
10 times VH monitor error [B200] The print head voltage is
abnormal.
1) Part replacement:
- Print head and logic board
(Replace them at the same time.)
- Power supply unit
11 times Carriage lift
mechanism
error
[5110] The carriage did not move
up or down properly.
1) Foreign material or paper debris that
obstructs the carriage movement;
remove foreign material.
2) Part replacement:
- Switch system unit
- Carriage unit
12 times APP position
error
[6A80] An error occurred in the
APP motor.
APP sensor
error
[6A90] An error occurred during
paper feeding or paper
ejection.
1) Foreign material or paper debris
around the purge drive system unit;
remove foreign material.
2) Foreign material or paper debris
around the ASF unit;
remove foreign material.
3) Cable connection
4) Part replacement:
- Purge drive system unit
- Logic board
14 times
Paper feed cam
sensor error
[6B10] An error occurred in the
paper feed cam sensor
during paper feeding from
the cassette, or the paper
absorbing a large amount
of ink jammed in the PF
rear guide.
1) Jammed paper in the PF rear guide
(when a large amount of ink was
absorbed in the paper);
remove the jammed paper and
foreign material.
2) Foreign material or paper debris in the
cassette or in the PF rear guide;
remove foreign material.
3) Part replacement:
- PF pick-up unit
- Logic board