Canon imagePROGRAF iPF8400, Руководство по обслуживанию

Страница: 250 / 308

Chapter 7
7-32
2) UGW Address [UGW-ADDRESS] and UGW port [UGW-PORT]
Usually, the default values set in advance are used for the setting value of [UGW-ADDRESS] and [UGW-PORT]. Unless there is a special instruction, the default
value should not be changed. If it should be changed, the communication with UGW may have an error. If [UGW-ADDRESS] and [UGW-PORT] are changed, the
new setting will be enabled after power OFF/ON.
Therefore, usually, the setup is not necessary.
* If you change under a special instruction, perform the following procedure.
(1) Setting address for UGW
- In service mode, referring to the "Service Mode Menu Tree", go to [UGW-ADDRESS] menu using key and key.
F-7-31
- Press key to enter the Setup Mode. (A character indicating the input mode (in the upper right corner of the screen) and the cursor are displayed.)
Enter UGW address (URL).
F-7-32
Display to indicate an input mode
A: Alphabet capital letter
a: Alphabet small letter
1: Numerical character
- The cursor is shown at the first letter.
- Use and keys to select characters to enter.
- Press [Back] key to cancel what you entered and go back to the previous screen.
- Press [OK] key to determine what you entered and go back to the previous screen.
(2) Setting up the GW Port Number
- In service mode, referring to the "Service Mode Menu Tree", go to [UGW-PORT] menu using key and key.
F-7-33
- Press key to enter the Setup Mode. (A cursor is displayed.)
Enter a port number.
F-7-34
- Use and keys to select characters to enter.
- Press [Back] key to cancel what you entered and go back to the previous screen.
- Press [OK] key to determine what you entered and go back to the previous screen.
* The actual setting value of UGW address [UGW-ADDRESS] and UGW port [UGW-PORT] are categorized as confidential information, so they are not described
in this manual.
3) Communication Test [COM-TEST]
(1) In service mode, referring to the "Service Mode Menu Tree", go to [COM-TEST] menu using key and key.
F-7-35
(2) Press [OK] key to start the test. ("=" is displayed at the start of the test.)
F-7-36
(3) During the communication test, "CHECK NOW" is displayed.
F-7-37
U G W A D D R E S S
E - R D S
U G W A D D R E S S
h t t p : / /
: a -
U G W P O R T
E - R D S
U G W P O R T
0 0 0 0 0
-
Y E S
C O M - T E S T
= Y E S
C O M - T E S T
C H E C K N O W . .
C O M - T E S T