Canon imagePROGRAF iPF6200, Руководство по обслуживанию

Страница: 660 / 692

Chapter 8
8-12
Hardware error.
03130031-4027
Turn off printer,
wait, then
turn on again.
03130031-4027 Lift travel timeout error Check the carriage unit and surrounding parts.
Hardware error.
03130031-2E13
Turn off printer,
wait, then
turn on again.
03130031-2F13 A/D converter external trigger output
stop detection hardware error 1 If both printheads are signaled faulty, take the
following corrective action:
1) Replace the left printhead with a normal one.
2) Because the error indication lasts, turn the printer
off, then back on.
3) Replace the right printhead with a normal one, as
the automatic replacement of the right printhead is
suggested.
If a printhead is not at fault, replace the main controller
board.
Hardware error.
03130031-2E32
Turn off printer,
wait, then
turn on again.
03130031-2F32 Multi sensor error Check the environment for interferences from outside
light.
Replace the multi sensor unit.
Cannot calibrate.
Press OK and try
calibration again.
03130031-2F34 Color calibration adjustment failure
error Check the environment for interferences from outside
light.
Replace the multi sensor unit.
Calibration
There is a problem
with the
multi-sensor.
Press OK to cancel
calibration.
03130031-2F35 Color calibration disabled Check the parts counter in service mode.
Replace the multi sensor unit.
Hardware error.
03130031-2F3A
Turn off printer,
wait, then
turn on again.
03130031-2F3A Valve motor error Check the ink supply unit.
Hardware error.
03130031-2F3B
Turn off printer,
wait, then
turn on again.
03130031-2F3B CS communication error Remove the ink tanks and then reload them.
Check the main controller PCB.
Hardware error.
03130031-260E
Turn off printer,
wait, then
turn on again.
0130031-260E Gap detection error Check the carriage unit and surrounding parts.
Replace the main controller PCB.
Hardware error.
03130031-2618
Turn off printer,
wait, then
turn on again.
03130031-2618 VH voltage error Check the power supply unit.
Hardware error.
03130031-260F
Turn off printer,
wait, then
turn on again.
03130031-260F Gap reference surface error Replace the reference surface sheet.
Roll feed unit err
Turn off printer and
check roll feed unit
03060A00-2E24 Roll feed unit failure Replace the roll feed unit.
Unknown file.
Check file format.
Turn off printer,
wait a while, then
turn it on again.
03900001-4049 ROM data for another model has been
transferred. Transmit valid ROM data.
Unknown file.
Check file format.
Turn off printer,
wait a while, then
turn it on again.
03900001-4042 MIT data transfer failure Verify the validity of MID data before transferring it.
Roll sensor
cannot detect.
Turn on printer
again.
03130031-291A Roll sensor detection failure Check the roll feed unit.
Display massage Code* Condition detected Action