Canon Image Reader-A1, Руководство по обслуживанию

Страница: 847 / 916

COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 CANON iR5000i/iR6000i REV.0 JUNE 2001
CHAPTER 5 SERVICE MODE
5-81 T
COPIER>OPTION
CONFIG
Use it to select multiple pieces of firmware retained on the hard disk so as
to make appropriate settings: country, language, model, paper size series.
Settings XXYYZZAA XX: country (JP), YY: language (ja), ZZ (00); model,
AA (00): paper size series; display will be in the following sequence and
the parentheses indicate default settings:
COPIER>DISPLAY>USER>LANGUAGE.
Using the Mode
1) Select CONFIG.
2) Select an item (to highlight), and press the +/- key.
3) Each press on the +/- key changes the contents in sequence.
4) When the appropriate setting has appeared for each item, press the
OK key.
5) Turn off and then on the main power switch.
RAW-DATA
Use it to print out received data as it is.
Settings 0: normal (default), 1: print raw data
WARM-UP
Use it to reduce the warm-up time if the room temperature is likely to be
about 18°C or higher when the machine is first turned on.
In the case of the iR5000 Series, the multiple rotation initial, standby, and
print start temperatures are reduced by 15°C.
In the case of the iR6000 Series (100-V model), the period of initial mul-
tiple rotation is reduced by 1 min.
Caution • For the 120/230-V model, the same control mechanism is used for both
iR6000 Series and iR5000 Series.
• This mode is disabled if FSPD-S1 is set.
Settings 0: standard (default), 1: reduced mode (as above)
SHARP
Use it to change the sharpness level of the image.
•
A higher setting makes the images sharper.
Settings 1 to 5 (default: 3)
LAPC-SW
Use it to switch laser APC correction.
Settings 0: ON (initial rotation APC executed if left alone for 10 min), 1: ON
(initial rotation ON APC executed if left alone for 60 min; default),
2: (initial rotation APC executed if left alone for 120 min)
3: initial rotation APC only off; 4: OFF