Canon Finisher-T1, Руководство по обслуживанию

Страница: 76 / 174

Chapter 3
3-14
F-3-51
3) Lift tray 2 [1] to remove it.
F-3-52
When installing the tray, be careful not to twist the
tray cable. To prevent the gear phase from shifting
due to the front and rear rails, the tray must be
attached horizontally. Lower the tray [1] to the
position shown in the figure and compare the
heights of the shutter guide top edges [2] with those
of the tray projections [3] at the front and rear to
check that the tray is attached horizontally. If their
heights are not the same, remove the tray and then
attach it again.
F-3-53
3.2.2.8 Removing the Grate-
shaped Lower Guide
0009-4498
1) Remove ten screws [1] and remove the grate-
shaped lower guide [2].
When replacing, be careful not to hook the grate-
shaped lower guide to the sensor flag arm on the
delivery side.
F-3-54
3.2.2.9 Removing the
Processing Tray
0009-3670
1) Unfasten four snap fasteners [1] and remove the
sensor flag [3] from the stack delivery roller [2].
[2]
[1]
[1]
[1]
[3]
[2]
[1]
[1]
[1]
[2]