Canon Finisher-T1, Руководство по обслуживанию

Страница: 104 / 174

Chapter 3
3-42
removed. Be careful not to loose it.
F-3-163
3) Remove all finisher controller PCB connectors[1]
and remove the harness from two clamp [2].
4) Remove four screws [3] and remove the finisher
controller PCB [4].
F-3-164
5) Release the claw [1] of the stack delivery roller rear
side clutch [2] and remove the clutch [2].
6) Remove the E ring [3], washer [4], and bearing [5]
and remove the stack delivery roller.
F-3-165
7) Disconnect two connectors [1] and remove harness
from the clamp and edge saddle [2].
8) Remove two screws [3] and pull out the processing
tray [4] in the paper delivery direction.
When removing parts inside the processing tray,
be careful not to exert force on the aligning plate
(front/rear) or the rear end stopper plate.
F-3-166
3.3.6.11 Removing the Swing
Unit
0009-3695
1)Remove two screws [1] and remove the solenoid
cover [2].
[6] [5] [4]
[1]
[2] [3]
[3]
[3]
[2] [1]
[4]
[2]
[2]
[3] [4] [5] [1]
[4]
[3] [3]
[2]
[1]