Canon EVERCAM XU-81, Руководство по эксплуатации

Страница: 32 / 58

E12
POWER TIME
TALLY
ALARM
MODEM
TEMP
SECONDS
TAKE FAN
-
+
WIPER WASHER
MEMO 5 6 7 8
PAGE 1 2 3 4
A B C D SHOT CAMERA
POWER
PANEL
LOCK
GAIN ND
SHUTTER
SELECT
L H 1 2 S F
IRIS
R GAIN
B GAIN
BAR AUTO AWB
-
+
WIDE TELE
NEAR FAR
AF
PUSH
PAN/TILT
OPERATION UNIT OP-300
③④
⑯
⑰
⑱
⑮ ⑭
⑪
⑬ ⑫
⑦
⑨
⑧
⑩
①
②
⑥
⑤
IS /
WDR
M-PED
EDGE
The section below describes operation using the OP-300.
[Switching the power ON/OFF]
Open the acrylic cover and press the ① POWER switch to switch the power ON and OFF.
NOTE
After the
① POWER switch is pressed, initialization is performed for several seconds until
is displayed in the ⑥ TIME display LED. Do not operate other switches during this
initialization period to prevent malfunction.
When the power is turned ON, is displayed in the ⑥ TIME display LED, and the system waits
for a response from the pan-tilt head.
After a few seconds when communication with the pan-tilt head is established, the shot movement
time is displayed (example: 11 s =
) and the other switches are enabled.
NOTE
Operation cannot be performed in the condition when communication is not established with
the pan-tilt head.
Note that in this case, the camera and pan-tilt head control items described below are
disabled.
[Before operating the pan-tilt head]
■ Warning alarm
Even when the communication is established, the ③ MODEM ALARM LED (red) lights when there
is no response from the pan-tilt head. This warns the operator that an alarm state has occurred in
the connected pan-tilt head or the circuit system.