Canon EOS 1V, Руководство по обслуживанию

Страница: 100 / 240

PREPARATIONS
1) On the SI unit, attach the screws
(X99-0689) and washer (CA1-
7752) that are used to attach the
SPC.
2) As shown on the right, slide off
the top cover, then connect the
transmission connector.
3) As shown below, place the camera
1.0 m +/-1 cm in front of the SI
Adjustment Chart.
4) On the Display Adjustment Menu,
select [F1] SI Position Adjustment.
Fig. 4-18
4) When the SI Adjustment Menu is
selected, the screen on the right will
appear. Move the camera so that all
the vertical and horizontal waveform
peaks (trapezoid) are centered.
ADJUSTMENT PROCEDURE
1) All the SI points will be lit. Look through the viewfinder and move the SI so that
the SI Adjustment Chart’s squares align (while attaining a good balance) with
the respective SI’s center, left, right, top, and bottom points.
2) When all the SI points are properly aligned, use Aron Alpha to fix it in place
temporarily. Then use Diabond to glue the entire SLC unit.
3) After completing the adjustment, press Return.
4-46
Part 4: Electrical Adjustments
Fig. 4-17
1.0m+/-1cm
SI Chart
SI_POSI
SI Positioning Adjustment
Set SI adjustment chart 1.0m away from the camera.
Set the waveform peak of AF sensor to the center,
then adjust SI Unit.
After adjustment, press RETURN.
Left Upper Center Under Right