Canon EOS-1D, Инструкция по эксплуатации

Страница: 47 / 176

47
Settings for Images
2
White Balance Auto Bracketing
Take the pictures.
s The bracketed shots will be taken in the following
sequence: standard color temperature, bluish
(minus), and reddish (plus). The bracketing indicator
for the next bracketed shot will also blink on the rear
LCD panel.
•
The current drive mode is used when you take the
bracketed shots. (
→
p.99)
•
If continuous shooting is used, holding down the
shutter button fully will capture all three bracketed
shots continuously and then the shooting will stop.
•
If the self-timer is also set, all three bracketed shots
will be taken continuously after the self-timer delay
of 2 sec. or 10 sec. elapses.
3
Indicator for the standard shot
Bluish (minus) compensation
Reddish (plus) compensation
Canceling White Balance Auto Bracketing
•
Follow steps
1
and
2
above to set the bracketing
amount to < >. Then let go of the < >
and < > buttons.
•
White balance auto bracketing will also be canceled
automatically after any of the following actions: the
CF card is replaced, the battery is replaced, a bulb
exposure is set, the flash is ready, the <
>
button is pressed, or the < > switch is set to
< >.
•
White balance auto bracketing cannot be used together with flash, bulb expo-
sures, or auto exposure bracketing (AEB).
•
If C.Fn-12-1 (mirror lockup) is used during white balance auto bracketing, the
bracketed shots will not be taken continuously even if the drive mode is set to
continuous shooting.
If the drive mode is single-frame shooting, press the shutter button once for each of
the three bracketed shots.
•
With C.Fn-09-2/3, you can change the white balance auto bracketing sequence.
(
→
p.135)
•
With C.Fn-09-1/3, you can prevent the white balance auto bracketing from being
canceled when you change the lens, replace the CF card, or set the <
> switch
to < >. (
→
p.135)
•
With C.Fn-01-1, you can still display the viewfinder information during continuous
shooting. (
→
p.133)