176
If there is a problem, first refer to this Troubleshooting Guide.
You are using the wrong battery.
X
Use the dedicated Ni-MH Pack. (p.22)
The battery is not properly attached to the charger.
X
Attach the battery properly to the charger. (p.22)
The battery is exhausted.
X
Recharge the battery. (p.22)
The battery is not installed properly.
X
Install the battery properly. (p.25)
The memory card slot is open.
X
Push in the memory card and close the memory card slot. (p.30)
If you set the <
4
> switch to <
2
> right after shooting, the
access lamp will still light or blink for a few seconds while the
image is recorded onto the memory card.
X
When the camera finishes recording the image to the memory
card, the access lamp will stop blinking and the power will turn off.
The battery is not fully charged.
X
Recharge the battery fully. (p.22)
The battery’s service life has expired.
X
Replace it with a new battery. (p.182)
Troubleshooting Guide
Power Source
The battery cannot be recharged.
The camera does not operate even when the <
4
> switch is set to <
1
>.
The access lamp lights or blinks even when the <
4
> switch is set to <
2
>.
The battery becomes exhausted quickly.