Trouble?
79
Ad
di
tio
na
l In
fo
rm
at
io
n
Memory Card Operation
Printing
Editing
No sound from the built-in
speaker.
Open the LCD panel.
–
Speaker volume is turned off. Adjust the volume with the
[SPEAKER VOLUME] setting.
Image will not appear on the
TV screen.
Check again that the camcorder is properly connected to the TV.
Tape is running, but image will
not appear on the TV screen.
TV/VIDEO selector on the TV is not set to VIDEO. Set the
selector to VIDEO.
Video heads are dirty. Clean the video heads.
You attempted to play back or dub copyright a protected tape.
Stop playback/dubbing.
Problem
Solution
Memory card cannot be
inserted.
Memory card was not facing the correct direction. Turn the
memory card over and reinsert it.
Cannot record on the memory
card.
Memory card is full. Erase still images to free some space or
replace the memory card.
Memory card was not initialized. Initialize the memory card.
The folder and file numbers have reached their maximum value.
Set [FILE NOS.] to [RESET] and insert a new memory card.
Memory card cannot be played
back.
Set the camcorder to
.
Image cannot be erased.
Image is protected. Cancel the protection.
The write-protect switch on an SD or SDHC memory card is set
to prevent accidental erasure. Change the position of the write-
protect switch.
–
“
” flashes in red.
Card error occurred. Turn off the camcorder. Remove and
reinsert the memory card. Initialize the memory card if flashing
persists.
Problem
Solution
The printer is not operating
even though the camcorder
and printer are correctly
connected.
Disconnect the USB cable and turn off the camcorder and the
printer. After a short while, turn them on again, set the
camcorder to
mode and restore the connection.
–
Problem
Solution
Cannot record with this
camcorder video input from an
external video device
connected using a DV cable.
Wrong signal standard. Refer also to the instruction manual of
the connected device.
–
Problem
Solution
