Canon Color imageRUNNER C4580, Руководство по обслуживанию

Страница: 163 / 851

Chapter 5
5-33
5.7.11 HDD
5.7.11.1 Preparation for Removing the
HDD
1) Remove the rear upper cover. (page 12-
22) Reference[Removing the Rear Upper Cover]
2) Remove the rear left cover (upper). (page 12-
23) Reference[Removing the Rear Left Cover
(Upper)]
3) Remove the left rear cover (upper). (page 12-
21) Reference[Removing the Left Rear Cover
(Upper)]
5.7.11.2 Removing the HDD
1) Remove the main controller box cover [3].
(Referring to Procedure 5.7.3.2)
Points to Note When Removing the HDD
Take care to avoid static damage when removing the
HDD.
It is also important to protect the HDD from impact.
2) Remove the HDD [4].
- 1 clamp [1]
- 2 connectors [2]
- 6 screws [3]
F-5-50
5.7.11.3 When Replacing the HDD
1. If NetSpot Accountant (NSA) Is Not Used
1) Formatting the HDD
While holding down the 2 and 8 keys on the
control panel, turn on the power to start up. Using
the HD formatting function of the SST, format all
partitions.
2) Downloading the Software
Using the SST, download the various software
(system, language, RUI). The machine will take
about 10 min to start up after downloading.
2. If NetSpot Accountant (NSA) Is Used Together
with a Card Reader
The card ID used by the NSA resides on the HDD. If
you have replaced the HDD, therefore, you will have
to newly download the card data from NSA to enable
the statistical operations of NSA. After going
through steps 1) and 2) above, perform the
following:
1) Set the following in service mode:
Select the following : COPIER >FUNCTION
>INSTALL >CARD; then, enter the number of
the first card, and press [OK].
(For instance, if cards No. 1 through No. 1000 are
used for group control, enter '1')
2) Turn off and then on the machine; when the
machine has started up, perform the following in
user mode:
Select the following : user mode >system control
settings >group ID control >count control; then,
check that IDs from 00000001 through 00001000
have been prepared.
Select the following : user mode >system control
settings >network settings >TCP/IP settings >IP
address; then, set up 'IP address' 'gateway address'
and 'subnet mask'
Select the following : user mode >system
administrator setup; then, fill in 'system control
group ID' and 'system control ID No.' thereafter,
turn off and then on the machine.
If you leave out 'system control group ID' and
'system control ID No.' the service engineer will
not be able to 'register card to device' as part of
setup work for NSA.
3) With the machine in standby state, download the
card ID to be used from NSA.
4) When the card data has been downloaded from
NSA, check that the ID data has correctly been
downloaded on the screen brought up by making
the following selections:
user mode>system control settings>group ID
control
(Only the downloaded ID data must be indicated.)
5) Make copies using a user card registered with
NSA, and check that statistical operations are
made for the device in question.
[1]
[2]
[2]
[3]
[3] [4]