35
ENGLIS
H
Adjusting the projected image
Adjusting the projection angle
The projector is equipped with 1 quick-release adjuster foot and 1
rear adjuster foot. These adjusters change the image height and
projection angle. To adjust the projector:
1.
Press the quick-release button and lift the front of the projector.
Once the image is positioned where you want it, release the
quick-release button to lock the foot in position.
2.
Screw the rear adjuster foot to fine tune the horizontal angle.
To retract the foot, hold up the projector while pressing the quick-
release button, then slowly lower the projector. Screw the rear
adjuster foot in a reverse direction.
If the projector is not placed on a flat surface or the screen and the
projector are not perpendicular to each other, the projected image
becomes trapezoidal. To correct this situation, see
for details.
•
Do not look into the lens while the lamp is on. The strong
light from the lamp may cause damage to your eyes.
•
Be careful when you press the adjuster button as it is close
to the exhaust vent where hot air comes from.
Auto-adjusting the image
In some cases, you may need to optimize the picture quality. To do
this, press
AUTO PC
on the projector or remote control. Within 3
seconds, the built-in Intelligent Auto Adjustment function will re-
adjust the values of Frequency and Clock to provide the best picture
quality.
The current source information will be displayed in the upper left
corner of the screen for 3 seconds.
•
The screen will be blank while AUTO PC is functioning.
•
This function is only available when a PC signal (analog
RGB) is selected.
Fine-tuning the image size and clarity
LV-WX320/LV-X320
For adjusting the size to your desired, you need to move the
product for appropriate projection distance because of small Zoom
ratio. Follow the procedure below for the installation and
adjustment.
The focus will be off after adjusting the zoom, so be sure to
readjust the focus. If the image is very blurry, adjusting the focus to
make the image sharp will change the size of the projected image.
Repeat the zoom and focus adjustments in alternation as necessary.
In the right figure, (A) Focus Ring, (B) Zoom Ring
1.
Adjust Zoom. (using (B) Zoom Ring)
2.
For the short distance/large screen, dial the ring fully to Wide
end. For the long distance/small screen, dial the ring fully to
Tele end.
3.
Adjust Focus. (using (A) Focus Ring)
4.
Move the product back and forth to adjust the screen size.
5.
Adjust Focus again if necessary.
2
1
B
A
Tele
Wide
