34
Switching input signal
The projector can be connected to multiple devices at the same time. However, it can only display one full
screen at a time.
Be sure the
Auto Search
function in the
INPUT
menu is
On
(which is the default of this projector) if you
want the projector to automatically search for the signals.
You can also manually cycle through the available input signals.
1.
Press
INPUT
on the projector or remote control. A source
selection bar is displayed.
2.
Press / until your desired signal is selected and press
OK/
IMAGE
.
Once detected, the selected source information will be displayed
on the screen for seconds. If there is multiple equipment
connected to the projector, repeat steps 1-2 to search for another
signal.
•
The brightness level of the projected image will change
accordingly when you switch between different input signals.
Data (graphic) "PC" presentations using mostly static images
are generally brighter than "Video" using mostly moving
images (movies).
•
The input signal type effects the options available for the
Image Mode. See
"Selecting a image mode" on page 39
for
details.
•
The native display resolution of this projector is in a 4:3 (LV-
X320/LV-X310ST)/16:10 (LV-WX320/LV-WX310ST) aspect ratio.
For best display picture results, you should select and use an
input signal which outputs at this resolution. Any other
resolutions will be scaled by the projector depending upon the
'aspect ratio' setting, which may cause some image distortion
or loss of picture clarity. See
"Selecting the aspect ratio" on
for details.
