Canoga Perkins Corporation, 20600 Prairie Street, Chatsworth, CA 91311-6008
Phone: (818) 718-6300, FAX (818) 718-6312 www.canoga.com
P/N 6943465 Rev A
Page 5 of 7
Step 6: Switch Configuration
From the Main Menu, type “1,” to access the System Configuration screen. This screen will
allow you to enter and configure SNMP parameters of the unit.
CANOGA PERKINS CORP.
HS8000 Hardened Ethernet Switch
System Configuration Menu
MAC Address 00 20 06 2A 33 C0
1. System Name
2. System Location
3. System Contact
4. Enable/Disable SNMP Access
5. SNMP Public Comm. Name
6. SNMP Private Comm. Name
7. Traps Configuration
8. Upgrade Software (Serial/TFTP)
9. Reset Configuration to Factory Default
0. Exit This Menu
Enter Selection by number:
Figure 7. System Configuration screen
Step 7: IP Address and Parameters
From the System Configuration Menu, type “5” to access the IP Parameters Configuration screen.
To configure the IP address, select “2” and type the IP address you wish to assign to the unit.
Press enter to accept the changes. The Subnet Mask and Default Gateway can be configured in
the same manner.
CANOGA PERKINS CORP.
HS8000 Hardened Ethernet Switch
IP Parameters Configuration
1. Enable/Disable DHCP/Bootp
DISABLED
IP Address in Use
2. IP Address
3. NetMask
4. Default Gateway
5. Save Values and Reset Switch
6. Ping Host
0. Discard Values and Exit this Menu
Enter Selection by number:
Figure 8. IP Parameters Configuration
