Canoga Perkins 9161, Руководство пользователя

Страница: 32 / 54

Manage Logged In Users
At times, you may need to monitor which users are currently logged in to the 9161 and, if needed,
you can force a specific session off (requires supervisor access). The User Log shows information
about the current users by session number; an asterisk (*) next to the session number indicates your
session. To access the User Log, follow these steps:
1. From the Main menu, type
4
, "Reports," and press <Enter>.
2. From the Reports menu, type
5
, "User Log," and press <Enter>.
3. To force a session off, type the number for that session and press <Enter>.
Note: Although a user with any level of access can view the information, a user must have
supervisor access to force a session off.
4. To return to the Main Menu, press <Esc>.
Set Up Host Access
The SNMP agent allows access to up to 24 Host IP addresses. Set up and edit the Host information
for the 9161 at the Host Access Table screen. To access the Host Access Table, follow these steps:
1. From the System menu type
4
, "Host Table/ SNMP Settings," and press <Enter>.
2. At the Host Access Table screen, type
2
to add a host, then at the prompt, enter the host IP
address and mask, or type
1
to edit a host. At the Add Host Access Entry screen, set values for
these parameters:
•
Telnet Access: Allow (Yes) or disallow (No) Telnet
•
FTP/TFTP: Select FTP, TFTP, Both, or None
•
SNMP Access: Select Write (also allows Read access), Write, or None
•
SNMP Protocol: Select V1V2cV3, V1V2c, or V3
•
V1/V2c Read and Write Communities: Enter name of community, up to 11 characters
•
V1/V2c Access Level: Select Supervisor, Operator, or Observer
3. To remove a host, type
3
, then follow the prompts.
4. To return to the System Menu, press <Esc>.
9161 Network Interface Device
3-18