20
Lefty Ocho 120 Owner’s Manual
138227 Rev 1 01/21)
Technical Information
Brake Hose Routing
Brake Hose Routing
1.
Loosen the 2.5mm hex bolt at the top of the
GuideGuard so the hose clamp can move freely.
Let the hose clamp hang downwards.
2.
Route the brake hose through the channel at
the top of the GuideGuard. Rotate the hose
clamp so it covers the brake hose. Torque and
the hose clamp to 1.5Nm with a 2.5mm hex
wrench.
1.5 N·m
3.
Check the brake hose and ensure that it does
not contact the Lefty lower leg, brake rotor or
wheel spokes.
a.
If the brake hose contacts the Lefty lower leg,
remove the StopLock brake mount, rotate
the brake caliper 360 degrees clockwise and
reinstall the brake mount.
b.
If the brake hose contacts the brake rotor or
wheel spokes, adjust the brake banjo angle
and/or loosen the hose clamp and draw more
brake hose above the GuideGuard.
4.
Unclip the upper cable guide from the fork by
pushing it upwards.
5.
Clip the bottom end of the C-tube over the
brake hose. Slide the C-tube downwards until
it bottoms out on the GuideGuard then clip
onto brake hose.
6.
Insert the brake hose through the split in the
back of the upper cable guide. Insert the upper
cable guide into the base and push down to
fully seat it.
Содержание Lefty Ocho 120
Страница 29: ......
