20
remote Cable Installation
Attach remote cable with shock unmounted from
frame.
1. Place bike in a work stand with the rear wheel
supported so the linkage does not move and the
shock can be positioned and reconnected.
2. Determine cable housing length. Allow sufficient
slack for proper shock operation and full
handlebar steering rotation. Too much housing
can interference with moving frame parts.
3. Install ferrules at both ends of the cable housing.
4. Set lever to FLOW - 180mm mode. Insert a new
derailleur cable (1.2 mm) into lever, housing end
through to the shock end.
5. Feed housing/cable under shock bridge, and into
the bottom of the shock spool chamber, and out
the shock cable anchor.
Make sure that you have
a new or cleanly snipped cable, or the anchor set
screw is backed out far enough. Otherwise, you
may have difficulty feeding the cable through the
spool chamber and past the anchor set screw.
WarnInG
HIGH PRESSURE HAZARD - Do not remove the spool
chamber end caps for any reason! Very high-
pressure can propel the end caps with extreme
force and velocity, potentially resulting in serious
injury or death.
6. Pulling the cable taut, tighten the cable anchor
1.5mm set screw firmly (
4-6 in-lb torque
).
7. Snip the cable 0.5” above the cable anchor, and
cap it.
Содержание Claymore
Страница 27: ......
