© 2001 Cannondale Corporation - All Rights Reserved
52
X440s Owner's Manual.fm
INSPECTING/REPLACING THE
SWINGARM BUFFER
SERVICE : Drive, swingarm buffer, thickness, standard
0.4 inches (10 mm)
SERVICE : Drive, swingarm buffer, thickness, minimum
0.1 inches (3 mm)
NOTE : Be sure to inspect the thickness of the buffer at a
few different points of its entire length. Wear may not be
uniform. If out of specification at any point, replace it with a
new one.
1.
Inspect the swingarm buffer for cracks, wear, or other
damage. Replace the swingarm buffer with a new one
if it is damaged or the wear (a) is out of specification.
2. To replace, place the vehicle on a suitable stand.
3. Remove the bolts and the old buffer. Make sure you
clean the buffer mounting screws with contact cleaner
and apply Loctite #242 agent before installing the new
buffer.
4. Install the new buffer and tighten screws to specified
torque.
TORQUE : Drive, swingarm buffer, mounting screws
17.0 lbf•in (0.19 N•m)
DRIVE CHAIN GUIDE AND BLOCK
SERVICE : Drive, chain guide block, thickness, standard
0.5 inches (12 mm)
SERVICE : Drive, chain guide block, thickness,
minimum
0.1 inches (3 mm)
Inspect the drive chain guide and drive chain guide block for
cracks, wear, or other damage. Replace the drive chain
guide block with a new one if it is damaged or the wear (a) is
out of specification.
Check the drive chain guide bolts and tighten to the
specified torque if necessary.
TORQUE : Drive, chain guide, mounting bolts
9 lbf•ft (12.2 N•m)
1.
Swingarm buffer
a. Thickness
a
1
1.
Drive chain guide
2.
Drive chain guide block
a. Maximum
wear
1
2
a
