Fitzroy Inbuilt
Model shown.
Red LED flashes twice approximately every
3 seconds to indicate that power is available.
When heater is operating in Back Up mode
the LED is on continuously.
In the rare instance of the Hand Held Unit failing to operate, the heater can
be operated manually by pressing the Back Up Switch button (once).
The switch is located where shown above.
For this Back Up Switch to operate correctly the batteries must be removed
from the Hand Held Unit.
In this Back Up mode, the heater will start up on Low Fire and Low Speed
Fan and then after approximately 3 minutes it will increase to High Fire and
Medium Speed Fan. (Speed 2)
Turn off the heater, press the Back Up Switch (once), the fire will extinguish
and the Fan will reduce to Low Speed and operate for approximately
3 minutes to assist with cooling down the heater.
In this mode there is no temperature control operating.
Back Up Switch.
Page 17.
QUICK START GUIDE
This Remote Thermostat is a room thermostat and to function correctly it
should be located in the same room as the heater within personal
comfort zone.
The thermostat is factory set with the default settings shown below and
will operate at settings indicated. If you wish to change these times or
temperatures see the Programming section later in manual.
Automatic Factory default settings
Factory default settings
Time Period Start Time Heat Temperature (°C)
Wake up. 6.00 am 20 °C
Away. 8.30 am 7 °C
Coming home. 5.00 pm 21 °C
Sleep. 10.30 pm 7 °C
The room will be maintained at set temperature during set period.
21°C
7°C
20°C
6.00AM
6.00AM
8.30AM
5.00PM
10.30PM
At any time during the automatic program period, the temperature can be
increased or decreased by pressing the “
UP
” or “
DOWN
” buttons.
To start heater.
Select “
PWR
” and “
OK
” buttons and press them together (then release).
Select Auto or Manual by pressing “
A/M
” button (then release).
The heater will only operate if the actual room temperature is lower
than the required temperature.
Manual Mode:
Press “
A/M
” Button to
select “Manual” mode.
The required temperature can be selected by using ‘
UP
’ or ‘
DOWN
’
buttons.
Room temperature is shown at top of screen.
Selected temperature shown at mid screen.
Automatic Mode
Press “
A/M”
Button to
select “Auto” mode.
Set
current
time and date. (See setting time and date later in manual.)
Page 2.
