3. To remove the inner glass: see Fig14.
Loosen off all the clamp screws.
Completely remove the one vertical side
and the top clamp.. Try not to touch the
front surface of the glass to avoid finger
marks. Remove the glass by sliding the
glass sideways out of the clamp and then
lifting out from the bottom. Place the glass
in a safe position for refit later.
1. Remove the wire mesh grille by gently lifting it upwards and then outwards.
Similarly remove a fitted glass kit by also gently lifting it upwards and then
outwards.
2. Remove 4 M5 screws fixing the fascia assembly to the heater body. Bring the
bottom of the fascia towards you gently to partly disengage it from the body of
the heater. After it has been disengaged gently lift it up vertically to completely
disengage it from the body of the heater. Refer figure 12.
17
FRONT FASCIA REMOVAL
To fully remove the fascia, unclip the switch cable
from the cable connector on the PCB and unclip the
cable from the clipping points on the rear of the
fascia.
14
(a) Place log no 1 onto the 2 front pins
on the burner head, ensuring that the
charring faces the front.
(b) Place log no 2 onto the two left
back pins.
( c) Place log no 3 onto the
single
right front pin, ensure the fork locates
over log no 2.
(d) Place log no 4 onto the
single right
back pin,
ensurezeft side of log rests in
the depression in log no 3.
Carefully unpack the log set. Logs are numbered
as follows:
no1 left front
no2 left back
no3 right front
no4 right back log.
Position the four individually numbered logs in the
following order on the burner as shown in
fig.15
The male locating pins in the burner must engage
with the corresponding holes in the individual logs.
see fig 15.
LOG INSTALLATION
FIG 15.
SHOWS POSITONING OF LOGS RELATIVE TO EACH OTHER.
Refit the front glass, slide into lower clamp and then
under side clamp. Make
sure that it is seated evenly on
sealing
rope. replace top and side clamp and secure.
Make sure not to over tighten the clamp screws.
Note: An air tight seal is to be achieved between
glass and seal. Care should be taken to achieve this.
REFITTING FRONT GLASS
FIG 16.
15
FIG 12.
FIG 13.
FIG 14.
The Cannon appliance is warranted against defects in materials and
Warranty service, which includes parts and labour for the replacement or
repair of defective parts, is available through the CANNON distributor.
(Details below or on page 24).
Consumers are responsible for service person’s travel outside normal
service areas (approximately seventy (70) kilometer radius from the nearest
Cannon dealer’s location), local transport costs, or any preventative
maintenance works as described in
Any product subjected to misuse, abuse, negligence, accident or alteration
will have its warranty voided. The defacement of serial plate will also void
warranty.
If installation is not carried out in accordance with manufacturer’s
instructions, this warranty may be void.
The customer must keep their “Tax Invoice” as proof of purchase of this
product and compliance certificate as proof of required installation.
workmanship for a period of two (2) years from its date of original
purchase, applicable only for residential use in Australia.
this manual.
Enter the details of the date installed and the Compliance Certificate
number in the appropriate area on the rear page of this manual.
