Cannon FITZFS-SDSEB-LP, Инструкция пользователя

Страница: 16 / 24

9
Gas type: Natural or Propane gas, as indicated
on data label
Gas consumption: 26 MJ/hr input
Energy output: 21.45 MJ/hr (5.96 KW)
Energy star rating: 4 stars
Heater type: Approved to AS4553:2008
Operating pressure: Natural gas: 0.75 kPa
(at the burner) Propane gas: 2.65 kPa
Gas regulator: Integral part of controller
Min. inlet pressure: 1.13 kPa (Nat Gas)
2.75 kPa (Propane)
Fan: 3 speed
Controller: Electronic direct spark
Power requirement: 240 VAC 10 Amp
Power consumption: 90 VA maximum
Optional Accessories: • Silver trim
• Cathedral ceiling flue box
Flue kit: 2 x 900mm lengths of 125mm ø painted
flue
1 x 900mm painted bottom flue c/w spigot
1 x 900mm length of 125mm ø plain flue
1 x ceiling ring
1 x 125mm AGA approved gas cowl
Overall dimensions: Refer fig. 8.
Heater specifications
8
Note:
The data plate is
located on the rear
of the removable
pedestal front.
16
This heater is a flued appliance. It must be properly connected to a flue
system in accordance with the latest edition of the Gas Installation Code,
AS 5601.
If elbows are required, we recommend 45
°
only and no more than two in
the total flue run. There should also be a minimum of 250mm straight flue
section in between bends.
If practical, locate the heater in a position to minimise the need for elbows.
There must be at least 1.8m of vertical before any changes in direction of
the flue.
If placed against a combustible wall the 40mm rear spacers locate against
the wall.
1. Ensure clearances to combustible constructions have been observed.
For clearances refer page 10.
2. The centre line of the flue is 115mm to rear of appliance (including rear
spacers).
3. Carry out installation as per figure 26 (ceiling plate installation) and
figure 27 (flue installation).
Cut a hole 180mm ø in the ceiling in line with the flue position. Secure
ceiling plate against the ceiling by bending out the tabs above the
ceiling.
Note: If the ceiling has an incline, a ceiling box will need to be fitted.
The ceiling box is an accessory and can be ordered from the supplier.
Installation instructions are supplied with the ceiling box. Part no: BOXFB.
Flue kit
The flue kit contains:
2 x 900mm lengths of 125mm ø painted upper flue
1 x 900mm painted bottom flue spigot
1 x 900mm length of 125mm ø plain flue
1 x ceiling ring
1 x 125mm AGA approved gas cowl
26
Flue installation