INSTALLING THE BOOM AND BALL HOOK
............................................................................................
1) Insert boom into frame (Figure 1) and line up
holes in boom with holes in frame. Note:
Easi-Troll units require the included boom adapter.
2) Remove 1/4-20 x 2” bolt and 1/4-20 nylon locknut
from included hardware bag assembly. (Figure 2)
3) Insert the 1/4-20 nylon locknut into the hex pocket
on the nose of the frame. (Figure 3)
4) Insert 1/4-20 x 2” bolt into reel side of frame nose.
With a Phillips head screw driver, thread bolt into nylon
locknut from step 3. Tighten bolt until the end of the
bolt is fl ush with the top of the nut. (Figure 4)
**TELESCOPIC BOOM ONLY**
To adjust the boom length (with the boom extending
away from you) rotate the clamps (See item # 7 on
page 5) approximately ¼ turn counter-clockwise to
unlock and slide the boom section to the desired position.
Once in place, lock the clamps by rotating clockwise until
tight.
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
Installation
