Installation
ATTACHING THE ROD HOLDER(S)
.........................................................................................
The locking rod holder(s) incorporate a locking tooth
design which can be easily adjusted every 15° with the
soft grip knob. **The unique two piece design allows
independent adjustment of the rod holder and the rod
holder arm in two axes. (Figure 7)
Caution:
This rod holder is intended for use of up to 30
lb. test line only and is not recommended for use with
any tackle IGFA (International Game Fish Association)
rated higher than 30 lb. A safety strap (not included) is
recommended for all applications.
NOTE: The rod holder assembly is not covered
under warranty when used with tackle above 30 lbs.
Equipment placed in the rod holders and the loss
thereof is the responsibility of the user and is in no
way warranted by Johnson Outdoors, Inc. Mounting
must be in accordance with the above instructions
and pictures to comply with the product warranty.
To install the rod holder(s):
1) **Fasten rod holder to rod holder elbow using
supplied spring and knob. (Figure 8)
2 ) Attach the rod holder to the downrigger on the left
side using the supplied spring and knob. (Figure 9)
The rod holder can be adjusted by loosening the
knob until the locking teeth are free from each other.
Rotate the rod holder or arm to the desired position and
re-tighten knob.
**Not applicable for Easi-Troll models.
FIGURE 7
FIGURE 8
FIGURE 9
