INSTALLING THE bOOM AND bALL HOOK
1. Remove the ball hook collar, ball hook, and 1/4-20 nut from the included hardware bag assembly. Thread the nut onto
the ball hook, then thread the ball hook into the ball hook collar. Do not tighten yet. (Figure 1)
2. Slide ball hook collar onto the end of the boom and leave it loose. (Figure 2)
3. Insert boom with ball hook collar assembly into frame (Figure 3) and line up holes in boom with holes in frame
(Figure 4).
4. Remove 1/4-20 x 2” bolt and 1/4-20 nylon locknut from included hardware bag assembly. Insert the 1/4-20 nylon
locknut into the hex pocket on the nose of the frame (motor side of frame) then insert 1/4-20 x 2” bolt into reel side of
frame nose. (Figure 5)
5. With a Phillips head screw driver, thread bolt into the nylon locknut from step 4. Tighten bolt until the end of the bolt is
fl ush with the top of the nut. (Figure 6)
6. Slide ball hook collar to your preferred location. Hand tighten the ball hook into boom tube. Tighten enough so that
there is no movement on the boom. (Figure 7) Once ball hook is secure, with a 7/16” wrench, tighten the 1/4-20 nut until
secure with ball hook collar. (Figure 8)
NOTE: Do not overtighten ball hook or permanent deformation of the boom is possible.
Figure 2
Figure 3
Figure 1
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
ASSEMbLy & INSTALLATION
