CANNON
®
CT-2000 Constant Temperature Bath
Revision 1.0g—February, 2012;
CANNON
®
Instrument Company
2139 High Tech Road • State College, PA 16803 • USA
5
CHAPTER
2
UNPACKING AND ASSEMBLY
This chapter of the manual provides assistance in unpacking and assem-
bling the CT-2000 Constant Temperature Bath.
Unpacking the CT-2000
1. Remove all components from the shipping container(s).
2. Remove any and all packing materials (Styrofoam, etc.) from the
components.
3. Verify reception of shipped materials by comparing equipment items
with packing/parts list(s). Report missing items to
CANNON
®
Instrument Company immediately.
4. Inspect each component for signs of damage. Report damages to the
shipper and to the
CANNON
®
Instrument Company immediately.
Damaged items
Retain all packing materials until the instrument is connected and func-
tioning properly. If any component(s) must be returned to
CANNON
®
Instrument Company, the damaged item(s) should be packaged in the
original shipping container. Refer to APPENDIX E of this manual for
instructions on returning defective equipment. Customers outside the
United States should contact the local
CANNON
®
agent for procedures
on returning products to
CANNON
®
.
The
CANNON
®
CT-2000 Constant Temperature Bath is shipped in
several boxes containing the following:
bath housing, including the electronics drawer
motor and stirrer, including the impeller and mounting plate
glass bath jar
Allen wrench
front glass panel pieces (2)
seven hole covers
jar gasket top and bottom
r
ubber thermometer holder
instruction manual
The bath unit housing is shipped completely assembled. However, the
glass jar, the glass panels, and the motor and stirrer must be installed. To
allow this, some disassembly of the bath unit housing is required. The
tools required are a utility knife, Phillips screwdriver, and a 1/8" Allen
wrench. The Allen wrench is included with the bath.
