Enter 30 End
*/$%ENTR* *ZEND*
4. General Setting
4-1-5 Scan Activation Time
In general, after Scan Button is pressed down, LED light will emit a stream of
light for a scan attempt. This parameter is thus used to specify activation
duration which indicates the amount of time LED light will stays on after Scan
button is pressed.
*0JH+*
Configuration Range Unit
Default Setting
1 ~ 30 Secs
1 Sec
10 Secs
4-1-6 GoodRead Beep Volume
Scan the appropriate barcode to disable Good Read Buzzer or set Good Read
Buzzer volume when a barcode is successfully decoded.
*7HZ0*
Disable
*7HZ1*
Level1
*7HZ2*
Level2
*7HZ3*
Level3
*7HZ4*
Level4
Procedure
(A) Scan “Enter” barcode
(B) Scan “Scan Activation Time” barcode
(C) Scan parameters from Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
4-1-6 GoodRead Beep Volume
4-1-5 Scan Activation Time
