Canford Panamic Series, Руководство по обслуживанию, Страница: 4 / 12

Page 3
To carry out the service below we recommend customers use the Panamic Maintenance Kit (Part Code: 53-5850)
which contains: Lithium Grease, Silicon Fluid and Allen Keys.
2.1 Undo knurled Thimble on each section and remove from mating section (see Fig.4 ).
Remove Rubber Bung from handle section.
NOTE: Rubber Bungs on Panamic poles 53-5801 & 53-5802 unscrew. All other poles have pull off Bungs.
2.2
Remove End Stops from the bottom of each section; to do this insert a small screw driver (or suitable
tool) through the cross holes and unscrew (see Fig.5 ).
NOTE: If the poles are old, the End Stops can seize in the Inserts and they will then need to be machined
out prior to the new End Stops being fitted. This is an operation that is best carried out by our skilled staff.
2.0 REPLACING THIMBLES AND BUSH SETS
1.6 Continue by reassembling the End Stop into the next consecutive section and following steps 1.4 & 1.5,
until the whole pole has been reassembled.
1.7 Replace Rubber Bung. Check again that the slide action is smooth for each section.
1.8 If a section feels tight or gritty readjustment maybe required - wipe clean and follow steps 1.4 & 1.5.
Fig.4
end stop
Fig.5