EBAC
To change the setting of any of these above shown parameters, User can select the desired one by Pressing
key. Already set value will be displayed. Press
to edit the setting. The value will start flashing.
Then use
keys to change the value and then press key to save the changed value.
Press
key --> and than press to exit that particular parameter editing.
Short Press
Short Press
Short Press
Short Press
Scroll Keys
Press key to test relay contacts in a sequence
Press to exit the Relay Contact Test.
Note: Contact Test will be blocked when load is connected.
C
Relay Contact Test
Test Menu
-tt-
Short Press
Sub menu screens for B/C
Press to see the below shown screen.
B
YES
AvTo
CA
Short Press
CA
Note: C/k ratio will not be calculated properly or can be miscalculated when load is unstable and varies quickly,
This may cause improper compensation. The better option is to disconnect the load and then start this process.
C/k will be calculated and stored in the memory. The calculated value can be viewed in C/k ratio setting ( ) under
programmable parameters.
In Auto C/k setup C/k value will be calculated based on first capacitor step rating. This capacitor is the smallest
size among the all capacitor steps connected.
12
