C&K systems SYS3316RF, Руководство по установке

Страница: 1 / 30

16.5 VAC
25 - 40 VA
50-60 Hz
Protected by Fuse
F2: 3 AG, 0.75 A
Shared with keypads
and AUX Power
UNSWITCHED
AUX POWER
KEYPAD INFORMATION
Do not exceed 4 keypads
or max AUX POWER
Protected by Fuse F3:
3 AG, 0.75 A
RED RED RED RED RED
BLK BLK BLK BLK BLK
BATTERY BATTERY
BATTERY BATTERY
BATTERY
Capacity for Capacity for
Capacity for Capacity for
Capacity for
emergency
emergency emergency emergency emergency
standby at
standby at standby at standby at standby at
least 4 hours
least 4 hours
least 4 hours least 4 hours
least 4 hours
CAUTION: Total power from
Terminals 3, 5, 7, and 8 NOT
to exceed 750 mA, combined.
NOTE: Z7 and Z8 must be
wired manually to the panel.
All ratings listed on this page are in compli-
ance with UL 985, UL 1023, and UL 1635.
DIRECT
CONNECT
WATCH
DOG
DS1 DS1
DS1 DS1 DS1
WARNING:
Circuit
Damage May Result
From Incorrect
Wiring Connections.
Red = incoming ring
Green = incoming tip
Gray = seized ring
Brown = seized tip
Blue = tamper
Orange = tamper
WARNINGS: WARNINGS: WARNINGS: WARNINGS: WARNINGS:
For continued protection For continued protection
For continued protection For continued protection
For continued protection
against risk of fire,
against risk of fire, against risk of fire, against risk of fire, against risk of fire,
replace fuses only with
replace fuses only with replace fuses only with replace fuses only with replace fuses only with
fuses of same type and
fuses of same type and fuses of same type and fuses of same type and fuses of same type and
rating
rating rating rating rating
PHONE CORDS PHONE CORDS
PHONE CORDS PHONE CORDS
PHONE CORDS
Use either:
- 9.X PCF
- 9.X PCP
U14 U14
U14 U14
U14
U6 U6 U6 U6 U6
F1 2.5A BELL FUSE
F2 0.75A AUX DEVICES
F3 0.75A KEYPAD
SN913-I/O
PROTECTED
BY FUSE F2:
3AG, 0.75A
P/N 5-051-396-00 Rev A P/N 5-051-396-00 Rev A P/N 5-051-396-00 Rev A P/N 5-051-396-00 Rev A P/N 5-051-396-00 Rev A
- All outputs are power limited
- Connect ground wire from door hinge to earth ground using
16 AWG, green jacketed, solid-conductor wire
- If programmed for EOL or Supervised loop, the 2.2K ohm EOL
resistor (Model 9.X, 2.2K) must be at end of circuit
GENERAL INFORMATION GENERAL INFORMATION GENERAL INFORMATION GENERAL INFORMATION GENERAL INFORMATION
- Loop voltages:
- Loop 8 can be used as standard loop or used for switched 10-
12.5 VDC at 50 mA for 2-wire powered devices. Loop 8 can
support up to 10 BRK Model 2400 2-wire smoke detectors.
Loop 7
0 - 2 VDC = short
2 - 3 VDC = normal
3 - 5 VDC = open
Loop 8
0 - 2.5 VDC = short
2.5 - 8.5 VDC =
normal
8.5 - 15 VDC = open
- SN913-I/O card requires 2.2 K ohm resistor (P/N 5-162-024-00)
- are electrically common
4 3 2
1
S1
TX
GND
V+
RX
ON
SWITCHED
AUX POWER
10 - 12 VDC
Protected by
Fuse F2:
3 AG, 0.75 A
12 VDC
6.5 AH or 9.5 AH
sealed lead-acid
POWER SUPPLY INFORMATION
- For non-Cal-Fire requirements, only use 12 VDC, 6.5 AH sealed
lead-acid battery, C&K Model #1265.
- For Cal-Fire Installations, use 12 VDC, 9.5 AH, sealed lead-acid
battery, C&K Model 1295.
- Replace battery every 3 - 5 years with C&K Model 1265 or 1295.
- Power demand for AUX POWER, keypads, and sounders not to
exceed maximum ratings.
- Install transformer (C&K Model 1097-B) on unswitched power
recepticle.
- Remove AC and battery power before replacing fuses.
- Maximum battery charge current = 350 mA.
- Standby battery time table with 1 Alpha keypad:
Battery Time Current
6.5 AH 7.5 Hrs. 500 mA
12 Hrs. 200 mA
9.5 AH 12 Hrs. 450 mA
24 Hrs. 56 mA
SYS3316RF Installation Instructions SYS3316RF Installation Instructions
SYS3316RF Installation Instructions SYS3316RF Installation Instructions
SYS3316RF Installation Instructions
AUDIBLE
10.5-13.5 VDC
Protected by Fuse
F1: 3AG, 2.5 A
Fuse F4 3 AG,
3 A battery
protection