Alexandrite Long Pulse Laser 755nm-GENTAL MAX PRO
5.4 Clinical treatment
Take the 755nm wavelength as an example. 1064nm wavelength is the same, which will
not be illustrated here again.
1. Enter the parameters according to different skin type, hair type
2. Removal all make up, clean the skin with water or soap, and take off the jewelry
accessories;
3. Take photos before treatment, set up files, and to contract after treatment. Note: When
taking photos, please turn off the strobe lights to make sure the picture with high
resolution image;
4. Deal with hair. To cut the hair with root left only. Then clean the hair clippings totally;
5. Clean the skin again;
6. Make sure all the presence of personnel being protected well. The operator and the
assistant need to ware protection goggles, the patient needs to wear eye-patch. If the
eye-patch is not suitable for the patient’s face, and leaks lights, please cut a strip of towel
and put it on the eyes and ware eye-patch on;
7. Press “standby” key to ready for treatment. Note: Testing skin area should be in the
center of treatment area and the skin is in average status.
8. Step the pedal, the long pulse light will out and the testing is end.
9. Observe the skin reaction, and communicate with patients for feelings, and then to
adjust the parameters. If the parameter is suitable, then start the treatment.
10. After the treatment, the spot should be closed to each other, without space and
repetition. If any emergency, press the emergency button, and close the machine
immediately and stop the operation.
11. After the treatment, keep the patient stay in bed for 20 minutes to observe.
5.5 System off
1. In standby mode, shut off the red tracing system, press the back button, the
system returns to the system selection interface
2. Turn left of the key, shut down, remove the key
3. Disconnect the power cord from the machine electrical outlet
5.6 Diameter Setting Guidance
Skin Type
Energy(J/CM2)
Pulse width(MS)
Frequency(HZ)
I
40%-60%
40-70ms
1-2
II
40%-60%
40-70ms
1-2
III
30%-50%
40-60ms
1-2
IV
20%-40%
30-40ms
1-2
V
15%-30%
20-30ms
1-2
VI
15%
10-20ms
1-2
20 / 32
