CANAWELD PLB2380148, Руководство пользователя

Страница: 15 / 32

14
(2) Mode selecting key
(3) Power/ Alarm indicator
Light up if the power switch on
Light up If the welder overheat, over-voltage or over-current. At the same time, display Err 001.
(4) Welding current adjust
Before the start of welding, you can use this potentiometer adjust welding current
(5) Welding current display
Display the pre-set or the actual welding current value.
Before the start of welding, it shows the pre-set current value
After the start of welding, it shows the present actual value of the welding current.
(6) Adjusting dial
If the parameter indicator lights up, then the selected parameter can be altered on adjusting dial.
Available parameters where 2T and 4T mode have been selected:
Gas pre-flow time
Unit S
Setting range 0.1
—
10
Factory setting 0.3