Canature 105STS 90 -1.5", Инструкции по установке, эксплуатации и обслуживанию

Страница: 67 / 94

General Maintenance Section 9
Page 9 — 9
Piston / Seal / Spacer (Lantern Ring) Replacement Section 9.2
- A special tool (PN. 70020033) should be used to remove and install seals & spacers. The
tool has four retractable pins. The pins are retracted or extended out by pulling or pushing
the center button on the opposite end. This tool works on all the spacers except the first
spacer which is usually pulled out by hand. The reason for this is the first spacer,
(05060098), has a slightly larger center hole, (54 mm in diameter compared to 50 mm for
all other spacers). It is critical, that this spacer is placed in the proper position when reas-
sembling. It is important to note the order the seals , spacer and o-rings are removed as
they must be installed in the correct order. They are not all the same.
- Insert the tool (PN. 70020033) into the valve body with the pins retracted, ( center
button pulled back). Push the tool tight against the spacer and push the button in. When
the button is pushed in, pins are pushed out to engage the holes in the spacer. The tool
may have to be rotated slightly to allow the pins to extend into the slots of the spacers.
105 Control Valve
#
1 Spacer—54 mm
center hole
All Other Spacers—
50 mm center hole