pg. 10
INSTRUCTIONS
• the slide switch is for FORWARD/REVERSE rotation
COLD weather set to FORWARD (clockwise) rotation.
*Airflow will be directed upward, circulating warm air
WARM weather set to REVERSE (counter-clockwise) rotation.
*Airflow will be directed downward, circulating cool air
REMOTE CONTROL -
install 9V battery (not included)
Operations on remote control:
CEILING FAN OPERATION
HI - fan high speed
MED - fan medium speed
LOW - fan low speed
OFF - fan off
LIGHT ON/OFF - light on/off
*DIMMER - light dimmer
*Hold down to increase or decrease the light. The light has a memory function so the
light will saty at the same brightness as the last time it was turned off.
DOWNDRAFT
UPDRAFT
reverse rotation
forward rotation
WARM WEATHER
COLD WEATHER
pg. 11
TROUBLE SHOOTING
TROUBLE
SUGGESTION
Fan will not start
• check fuses and circuit breakers
• check wiring connections to the fan
• check wiring connections in switch housing
*CAUTION: Turn power off for last two items
Fan sounds noisy
• check to make sure that all screws in motor housing are snug
• check to make sure that blade bracket screws are tight
• check to make sure marrettes in switch housing are not
rattling against the wall of the switch housing
• if fan has a light kit make sure switch housing, screws and
set screws are tight
• some fan motors are sensitive to signals from solid state
variable controls. If solid state controller is used, change to
alternative control (See a Canarm representative for a list of
available controls.)
• allow a 24 hour break in period to eliminate noises
Fan wobbles or
shakes excessively
• check that all blades are screwed firmly into blade brackets
• check that all blade brackets are secured firmly to motor
• check distance from tip of blades to ceiling. Gently bend
the blade brackets up or down until all distances are the same
• check distance between blade tip to blade tip.
All measurements should be equal. Loosen blade screws
and position blade until even then re-tighten
• check that the downrod hemisphere notch is engaged in canopy
• check to make sure that jam screws in downrod are tightened
• make sure canopy and mounting bracket are tightened
securely to wooden joist
• make sure warpage has not occurred in wooden blades.
If so, contact the Canarm customer service department for
replacement parts
• occasionally slight weight variations can be caused by
moisture during transportation. All fans are supplied with
balancing kits and installation instructions to eliminate this
problem
