17
Sump drain
Pump - tap
Changing Engine Oil
1.
Run the engine for 10 minutes to warm up the oil.
2.
Your engine is provided with a sump drain pump. Turn the tap to “on”.
Use the hand pump as shown to pump out the oil into a bucket. Turn the
tap to off position and replace end cap.
3.
Unscrew the oil filter and replace with a new one. See diagram below
Note: it is best to have a plastic bag wrapped around the filter to catch any oil left
in the system. (Always keep your bilges clean!) Before screwing in the new filter
spread a thin film of oil round the rubber gasket to ensure a good seal and screw
in – hand tight.
4.
Fill the engine with new oil, refer to page 13 for specification, as described
above.
Note: once you have re-filled the engine will oil, run the engine for about 5
minutes, so the oil can be pumped around the engine and into the new filter. Stop
the engine, and let it settle for about 10 minutes, and re-check the oil level, fill if
required.
Sump drain
Pump
Oil Filter
