O K A N A G A N / S A S K A T O O N / G A N D E R / M U S K O K A S P A S
(11)
Spa Behavior
Pump
Press the “Jets” button once to turn the pump on or off, and to shift between low and high speeds if equipped.
If left running, the pump will turn off after a time-out period.
The low-speed of pump 1 runs. If the spa is in Ready Mode the Pump may also activate once in a while for at least 1 minute to
detect the spa temperature (polling)and then to heat to the set temperature if needed. When the low-speed turns on
automatically, it cannot be deactivated from the panel, however the high speed may be started.
Filtration and Ozone
Pump 1 low and the ozone generator will run during filtration.
The system is factory-programmed with one filter cycle that will run in the evening (assuming the time-of-day is properly set)
when energy rates are often lower. The filter time and duration are programmable.
A second filter cycle can be enabled as needed.
At the start of each filter cycle, all water devices (other than the primary pump) will run briefly to purge the plumbing to
maintain good water quality.
Freeze Protection
If the temperature sensors within the heater detect a low enough temperature, then the pump automatically
activate to provide freeze protection. The pump will run either continuously or periodically depending on conditions.
In colder climates, an optional freeze sensor may be added to protect against freeze conditions that may not be sensed by
the standard sensors. Auxiliary freeze sensor protection acts similarly except with the temperature thresholds determined by
the switch. See your dealer for details.
Clean-up Cycle (optional)
When a pump is turned on by a button press, a clean-up cycle begins 30 minutes after the pump is turned off or times out.
The pump and the ozone generator will run for 30 minutes or more, depending on the system.
Preferences
F / C
(Temp Display)
Change the temperature between Fahrenheit and Celsius.
12 / 24
(Time Display)
Change the clock between 12 hr and 24 hr display.
