J
I
I
H
K
Positiion
stopper
1st
H
I
2nd
STEP 7
Hold the 'position stopper' facing the front of the chair and set it upright into the
first reclining position above the back of the chair. Slat (K) should sit perfectly in
the notch. Turn the upper back support (J) so that the notches are facing the front
of the chair.
STEP 8
Take the end of the armrest (H) and secure it to the 'position stopper'. Make sure
that the front legs of the chair remain upright. Use two large screws and slide a
washer over each screw. Turn the screws from the inside through the remaining
low holes on top of the armrest. Use a spirit level to check that everything is level.
Fasten the four remaining hinge screws - two under the armrest and two under
the triangle.
STEP 9
Now lay all seven slats (L) in the right order with the longest slat in the middle.
Place three slats to the left and three to the right of the longest slat so that the top
forms a curved line. Do not place the 2 outer slats too far to the outside, because
the entire backrest must be able to pass. Remember! The countersunk edges of
the holes should face upwards. Take the middle, longest slat and fasten it using a
4x40 mm screw to the low rear support (D) and then to the upper back support (J),
also with a 4x40 mm screw. Make sure that the underside fits exactly in the notch
and that the edge of the slat is flush with the edge of the low back support.
