B
Back!!
A
C
Front!!
STEP 1
Lay the sidepieces (A) with the curved sides uppermost on a smooth surface. Next,
set the crossbar (B) at the back of (A) into the middle notch between the two
deeper fixing slots. Screw the slat firmly in place with one 4x40 mm screw on each
side. Make sure that the countersunk edge of the pre-drilled holes is facing
upwards. Now take the slats (C) and place them in the notches. Make sure that the
outermost edges of the slats are precisely aligned with the outermost edges of the
notches and that the countersunk edges of the pre-drilled holes is facing upwards
again. Secure the slats on each side with a 4x40 mm screw. Begin from the
bottom. Do NOT attach part (M) yet.
STEP 2
Now fix the low rear support (D) between the sidepieces (A). Take two washers
and two large screws. Slide a washer over each large screw. Attach the large
screws from the outside on the right and left through the large holes at the back
of sidepieces (A). Place part (D) in the middle and secure it. Make sure that the
plank fits properly. Do not turn the screws too tight. Plank (D) must be able to be
turned round.
STEP 3
Take two nuts and place them from the inside in the large holes at the front of the
chair. Take the chair legs (E) and secure them on the outside of parts (A). Screw
the bolts fast on the outside. Make sure that the slanted edge of the legs is facing
the front and that the countersunk edge of the pre-drilled holes is facing the inside
of the chair.
B
