I
!
!
X
X
4x30mm
Do not
screw!
H
H
STEP 7
Now attach plank (I) on either side using only one 4x30 mm screw. Use only the
first
hole! Do not attach the other two screws yet. This gives you the opportunity
to align the armrests with the upper back support (I). Turn the armrest to the right
and to the left until the edges of the armrests of plank (I) form a nice, even curve.
STEP 8
Turn the armrest frame over and set it on top of the armrest supports (G). It
should form one integrated piece. Make sure that the armrests are straight and
that the innermost curved edges are flush with the curved edge of the weight-
bearing plank (G0 underneath. If everything is in the right position, continue with
Step 9. (H) should be at the back, overlapping (G) by about 1.5 cm!
STEP 9
Screw the remaining 4x30 mm screws into the two holes in the upper back
support (I). (See Step 7) Now take six 4x30 mm screws and, from underneath,
screw two on each side through the armrest planks (G) into the armrest (H).
