Flush
!
E
D
Flush!!
E
correct
incorrect
G
D
E
D
G
I
Back
H
H
Front
STEP 4
Put two nuts in the large pre-drilled holes at the front of sidepiece (A). Attach
legs (E) with two bolts to sidepiece (A). Repeat on the other side of the chair. Now
balance the chair. Move it forwards and backwards until it is standing steady and
the top and bottom of the front and back legs are flush.
STEP 5
The armrest support: place the armrest support (G) on top of legs (D) and (E).
Make sure the countersunk edges of the pre-drilled holes are facing upwards and
that the innermost edge is parallel to the innermost edge at the top of the legs.
The plank should also be flush with the foremost edge of the front leg. Please
note: ensure that the seat frame structure is at right angles. Now fasten the plank
to the top of the legs using four 4x40 mm screws. Repeat on the other side of the
chair.
STEP 6
Use the two armrests (H) and the upper back support (I) to make the armrest
frame. Lay the armrests upside down on a flat surface with the curved sides facing
each other. Place the upper back support (I) precisely on top of the rear end of the
armrests. The countersunk edges of the pre-drilled holes should face upwards.
Make sure that part (I) is flush with the one underneath.
